Jump to content
Sign in to follow this  
wickham

Skystar HD2 & Airstar 2 & EMP-Centauri P.168-W switch

Recommended Posts

wickham

Hi All,

 

 

I have a problem with using DVB-T and DVB-S card in DVBViewer with P.168-w swich.

This swich can merge antenna and sat singnal for one cabel after I have to separate them with diplexer and connect to the right card.

Unfortunately under DVBViewer I cannot wach dvb-t and dvb-s channels without freezing dvb-t. When connected both cabel to the cards dvb-t signal lose.

 

EMP-Centauri support saying this:

 

"you use the same software, but it controls 2 different pieces of hardware. There is good hope that if you would be able to switch one PC card off while you are using the other, the problem will disappear"

 

So when I wach dvb-t, skystar card should be off and when i change channels to dvb-s should be on again and vica versa.

 

Could it be possible?

 

Thx

 

wickham

Edited by wickham

Share this post


Link to post
This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...