Multytenne + DVBViewer Pro + Skytar USB

[bastjuan]

Hi,

 

Sorry for my english.

 

I have :

 

- [satellite] Technisat Multytenne

- Skystar USB

- DVBViewer Pro

 

I haved tested the Technisat Multytenne with a TV installation and all is OK.

 

But I have a problem with the Skystar USB and DVBViewer.

 

- Astra 19.2°E : OK

- HotBird 13.0°E : not OK

When I scan the HotBird Channels, when I scan the HotBird Channels, I found only some ASTRA channels (51).

 

Must I configure server4PC with DVBViewer Pro ?

Is DVBViewer Pro compatible with Multytenne or Skystar USB ?

Must I configure the DiseqC in the DVBViewer Pro ? If yes, where ?

 

Thanks very much for your help.

 

JLB

[hdv]

Hello,

 

Must I configure server4PC with DVBViewer Pro ?

no, it can removed from autostart.

there is only needed if you use internet over satellite.

Is DVBViewer Pro compatible with Multytenne or Skystar USB ?

yes. which driver you use? the bda or wdm driver?

for best results use the wdm driver, only with this diseqc is possible.

Must I configure the DiseqC in the DVBViewer Pro ? If yes, where ?

yes. i don't know which sat is on which position.

the best is you test the four option (Pos A/Opt A, Pos B/Opt A) and so on.

 

[Griga]

I'm using the Multytenne with good results (though not with a SkyStar USB). DiSEqC must be assigned in the following way:

 

A/A Astra 19° E

B/A Hotbird

A/B Astra 23° E

B/B Astra 28° E

 

Go to Channel -> Channel Editor. Select the root folder with the according satellite position and set DiSEqC on the right.

[bastjuan]

Hello,

 

Thanks for your help.

 

I have configured the diseqC :

 

A/A Astra 19° E

B/A Hotbird

A/B Astra 23° E

B/B Astra 28° E

 

(thanks Griga)

 

Then I have downloaded the lastest drivers (4.4.1.0) and I have installed the WDM driver.

 

Astra is always OK.

 

But the scanning of the Hotbird channels is not OK : only 61 programs found...

 

I will start again at 0...