Channel scan on 3 LNB's?

[Laserwave]

Hi there... sorry if this a dumb one, but I've got a 3-LNB, fixed single-dish installation, with LNB1 being ASTRA 19.2, 2=HotBird 13 and 3=Eutelsat W2 16.

I can't find a way to scan the third one, and can only scan and watch through Astra and Hotbird. All DiseqC options (Pos A/B, Opt A/;) refer to LNB 1 and 2. How can I scan channels for the Eutelsat W2 on LNB 3?

 

Thanks a lot

[Darwin]

The only important question:

 

Type of DiSEqC switch(es) ?

Edited June 14, 2008 by Darwin

[Laserwave]

Thanks.

 

Sorry, I know almost nothing about satellite equipment so I'll refer the "Antenna Setting" menu of my Humax 5400Z, which is also connected to the same dish, and can see all 3 satellites.

 

1. Antenna Alternative = 3 (1=Astra, 2=Hotbird)

2. Satellite Name = Eutelsat W2

3. LNB Frequency = Universal

4. 22kHz Tone = Disabled

5. 0/12 Volt Switch = Disabled

6. DiseqC Input = DiseqC C (the other available options here are: "DiseqC A", "DiseqC B", "DiseqC D", "Tone Burst A", "Tone Burst B" and "disabled")

7. Motorised Switch = Disabled

[Darwin]

I try to translate:

 

Humax ------> DVBViewer

===================

DiSEqC A -> PosA/OptA

DiSEqC B -> PosB/OptA

DiSEqC C -> PosA/OptB

DiSEqC D -> PosB/OptB

 

Check in DVBViwer for all LNBs:

LOF1 = 9750

LOF 2 = 10600

LOF SW = 11700

(== universal LNB)

 

and don't forget to check the right "Pos/Opt to Sat"-Choice everytime you scan.

(DVBViewer forgets to persist... )