No Picture after switching sats

[vondoogle]

I managed to get the motor going in the end after following mr Chalea advise of using discq.exe to build the strings to overcome the bug with western sats in DVBV Pro, anyway when I change channels on another sat the picture does not display, the motor will move fine.

 

I have no signal level or other info in the bottom bar, if I rebuild the graph then the picture will display and I can change channels within the same sat, but when I move to another sat then the problem starts again until I rebuild the graph.

 

Any ideas what might be causing this?

 

My System is:

 

Technotrend budget S2-3200 PCI Card

Asus P5E-VM HDMI MB

Intel E8500 core duo

2GB ram

Vista Ultimate SP1

DVBV 3.9.4.0

Edited September 22, 2008 by vondoogle

[Valts]

Believe one of suggested solutions was to set 'retune on missing stream' in the hardware options.

[vondoogle]

Believe one of suggested solutions was to set 'retune on missing stream' in the hardware options.

 

 

Cheers, set it to 3 seconds and all sorted

 

Vondoogle

[newm]

i have same prob as this but rtune did not work for me tried everything just cant sort it my specs are

amd phennom x4

ati radeon 32oo built in hdmi

win 7 x64

floppydtv s2

msi mobo

4gb ram

did have it all working but had to change my mobo and now have this prob can any1 help please

[humando65]

Hello,

 

Same problem with me too.

 

To avoid double posts, check the subject here:

 

http://www.DVBViewer.info/forum/index.php?showtopic=36189

 

Thanks.