No Hardware Available after service recording.

[HomerDK]

Hello.

 

After a recording made trough the recording service, I get the No hardware available message when starting DVBViewer.

I must stop the service and start it again, then it works.

This "problem" also prevent my PC to go standby after a timer recording.

 

I'm using the MCE Standby tool, to see whats happening and under "windows idle" tab, I can see that 5-10 seconds after the service recording the "One or more programs require the system" goes red again. Stopping and starting the rec service fix this temporarily, because after about 5 minutes the rec service does it again and if I try to start DVBViewer I get the No hardware message again.

 

Any suggestions on how I can fix this?

 

Thx

Edited May 19, 2010 by HomerDK

[Prinz]

After a recording made trough the recording service, I get the No hardware available message when starting DVBViewer.

 

Could it be, that you aren't using a Unicast Device in the DVBViewer?

 

The necessary DVBViewer settings are described in the wiki in section "Setting DVBViewer".

 

Here is the URL auf the chapter:

http://en.DVBViewer.tv/wiki/Recording_Serv...tallation_Guide

 

 

Otherwise more information is necessary. Could you follow these instructions:

http://www.DVBViewer.info/forum/index.php?showtopic=2210

 

Regards

Prinz

Edited May 19, 2010 by Prinz