CellZapper Posted June 29, 2009 Share Posted June 29, 2009 (edited) as a result of my trying to get my compro s350 diseqc working I came across this minor problem (but it gets you going round in few circles, before you realise it don't mean it) got to channel editor in DVBViewer, and setup diseqc on satellite level. select diseqc preset pos set preset position to a value , in this case 3 apply and move to another sat (to set this new sat diseqc up) Go back to original sat the position number has changed to a number reflecting its angular position DUH!!! very confused set diseqc setting to "none" is a quick way to reset position number to zero. (because you have to click it down you can't type a new number in)(I supose that is another BUGlet) I went around the loop several times before I found that the channels on the sat had been set correctly to the position number I was inserting. Can something be done so when returning to check/reset the diseqc position on a satellite that the position is correctly set to the one I put in, not the angulsr position. Regards chris support_plus.zip Edited June 29, 2009 by CellZapper Quote Link to comment
Griga Posted July 2, 2009 Share Posted July 2, 2009 Thanks for feedback. Will be fixed in the next beta release. Quote Link to comment
CellZapper Posted July 2, 2009 Author Share Posted July 2, 2009 Thanks for feedback. Will be fixed in the next beta release. Thanks Griga You are a star. Regards Chris Quote Link to comment
Griga Posted July 2, 2009 Share Posted July 2, 2009 Well, actually Lars has fixed it. I've only drawn his attention to it. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.