Remote control for TT

[bral]

After couple hours of searching how to set TT remote control now i post the complete tutorial for newbies.

 

 

The new TT Remote Inputplugin can be found in the Membersarea -> section.

 

QUOTE

This Plugin enables you to use the remote controls of Technotrend cards directly with the DVBViewer Pro.

 

Installation:

- Extract the archive into the DVBViewer Pro plugin folder.

- Start DVBViewer und choose options -> Input -> Input Plugins

- You should see the "Technotrend remote" plugin in the plugin list.

- Activate it by checking the box in front of the plugin name.

- Select settings (button on the lower right). This shows the settings dialog of the plugin.

- In this dialog select the device you want to use. Leave the dialog by pressing OK.

- Now you can learn the remote keys in the "Input" section of the DVBViewer options.( Guest_Lars_MQ_*)

 

The manual isn't updated... nowadays to assign keybard key's to command you have to:

• go to "Settings / Options /Input"

• press the "Learn" button (it remain pressed until you click on it again...)

+ select the desired command

+ press a key (or combination of...) or a remote button

• repeat the above two + signed line for how many command you want associate/change

• click again on "Learn" to disable the learn session

• click on "Save" button & "Ok" and you are ready to go...

(as you can see you can also "Export" & "Import" the whole set or a subset of key/remote button assignment...)

 

...but you want a key to minimize DVBViewer that's not listed among the standard one's...

so you addictionally have to add a "special" command, i.e an "action"; do so:

• go to "Settings / Options /Input"

• click on the list where you want to place a new "special" command

• click on "Add" button (you can also add a new group of command, just press "Add group" and name it...)

• give a name to the command (e.g. "Minimize" in you case)

• in the "Actioneditor" windows open the top right drop down list

• search and select "WindowMinimize"

• click on "Add" button (you can add more than one command in the same "action", for example you may want also add "Mute"...)

• click on "ok" button

• assing a key/remote button with the above procedure and you are ready to go...

 

...finally I'm guessing you need another command to restore DVBViewer:

now you know how to, the specific action is "WindowRestore"... ( Groxy)

 

 

regards