mborkP Posted October 9, 2010 Share Posted October 9, 2010 Hi, I've Sat. Card which has 2 S-2 tuners on board. In DVBViewer settings, both tuners are listed as A and B Is there a way that the Unicast Network Device will see just one tuner? I.E. Is it possible to set up 2 Unicast Devices and assign each to different tuner? Thanks Quote Link to comment
Lakeuk Posted October 9, 2010 Share Posted October 9, 2010 Wiki has instructions for setting it up:- http://en.DVBViewer.tv/wiki/Recording_Service_Installation_Guide#Create_Unicast_Devices Quote Link to comment
mborkP Posted October 9, 2010 Author Share Posted October 9, 2010 (edited) Wiki has instructions for setting it up:- http://en.DVBViewer.tv/wiki/Recording_Service_Installation_Guide#Create_Unicast_Devices Thanks. I did setup rec.srv. but still have a problem as with pre 4.5 betas. Problem is that when I record HD channel and while recording change to another HD channel I got "hardware not availible" message. If, while recording HD, I change to SD channel there there is no problems. If I run DVBV without rec.srv. I can record and watch HD or SD channels at the same time with no problems. This is for instant recording. Also I noticed that the v4.5 is very sensitive to codecs, with some it start to pixelate, audio is out of sync ect. I did not have this behaviour prior to v.4.5. It crashes all the time with ATI codecs. Maybe this is ATI drivers problem, not sure. Cheers Edited October 9, 2010 by mborkP Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.