DVBServer select wronge network card

[hsv]

I have the following setup

 

Motherboard Supermicro X9SCM

It has on-board two nics

82574L 192.168.11.152

82579LM 192.168.11.164

 

When I configure DVBServer to use 192.168.11.164

I cannot connect to it.

On the server when I connect to 127.0.0.1 I can see under

"Device Status" that the server are lising to 127.0.0.1 and 192.168.11.152.

And when I configure it to use 192.168.11.152 it shows 127.0.0.1 and 192.168.11.164

 

I use the same ip number all over in the configuration but when I setup DVBViewer I cannot use the same IP number everywhere. But it will not connect with the right ip number in the recordingservice.

 

When I have tried to setup DVBViewer with both IP numbers

Now I can see the channel list but when I try to see a channel it says that the hardware is not available.

 

If I connect to WEB interface :8089 I can connect to it and from here I can open a channel and see TV and setup recording.

[Lars_MQ]

the dvbserver is no longer supported. please use the Recording Service.

[Tjod]

I think he is talking about the DVBServer in the RS

The old DVBServer has no web interface.

[hsv]

Hi Tjod

You are right:-) I have followed this WIKI

http://en.DVBViewer.tv/wiki/Options_Service_-_DVBServer

 

But because of the lack of control of the networks cards I cannot get it to work in the clients. I am looking forward to a fix for this.

 

Because at the moment I can only use the web interface.

 

Have you reproduced the problem?

[Tjod]

Have you tried Automatic?

The RS should use than all network devices.

[hsv]

Hi Tjod

I got it working by using telnet and the port number to tjek what works or not.

So I have selected the right ip-numbers. But still it is a bug.

Also I found out that I have to setup the hardware units on the clilent to the same as hardware on the server.

 

Regards

Henning